We show you how to open most common types of drains. TBD How to Unclog a Bathtub Drain—the drop stopper type Close-up of a drop stopper A drop stopper has a prominent knob that you lift and turn to open the drain. The problem is usually just a sticky wad of hair that collects on the crossbars, a few inches under the stopper. If hair is wrapped around the crossbars, slice through it with a utility knife and then grab it with the wire. Follow our series of photos to determine which type of stopper you have and how to remove it. Clearing a Drop Stopper Drain The most common type, a drop stopper, has a setscrew located under the cap. These stoppers lock and seal when you press them down and release when you push down a second time.

How To: Unclog a Bathtub

Set the hook aside. If your tub has a stopper, there are different methods to remove it, depending on type. Removing a drop stopper that you twist half a turn to pop down and close, a screwdriver is required.

Here are a few bathtub drain schematics and bathtub plumbing diagrams. Fairly simple drain system. If you have to hold your drain lever down for the tub to drain it is more than likely the tension spring on the back of the overflow plate.

It wipes off quickly and has few joints to catch mold-attracting dirt and scum. And the unit is much easier to install. Most models consist of a tub plus three shower wall panels, which all interlock and seal. OK, a full weekend. This project is a bit complex for a beginner. This price tag could easily double with a higher priced tub and surround and fancier valves. Begin by measuring the approximate length and width of your existing bathtub.

Can I Hook Up a Shower and Tub Drain To a Washing Machine Drain?

If the water is always reaching your feet or even higher every time you take a shower, then you most likely have a clogged bathtub drain problem. It is a bigger problem to fix but not impossible. Mostly the hairs in the strainer are clogging the bathtub.

Sep 13,  · How to Install a Bathtub. Apply a ring of plumber’s putty around the drain flange, tape up the drain flange threads, insert the washer on the shoe and carefully position it. Then screw the drain flange in the shoe and tighten it. 7. Attach the drain to the tub and screw it securely in place. %(4).

The bathtub drain usually gets clogged with hair or sometimes even small soap chips. There are also other reasons why the bathtub drain might be clogged like for example if the house is real old and has galvanized pipes. The Bathtub drain can be cleaned and unclogged using a plumbers snake, and sometimes a plunger depending on how bad the clog is. In some cases where the drain is not completely clogged you maybe even be able to use a type of liquid drain cleaner like Liquid plumber or similar product.

Its always best not to only have the drain unclogged but also cleaned and flushed out. Here are the top ten questions about unclogging bathtub drains with some answers that may help you have a good draining bathtub once again in no time. As we mentioned above you can use a few different things to unclog your bathtub. You can use a plunger, plumbers manual steel snake or even an electric hand snake, and sometimes even liquid plumber.

Faucet Handles

If you exclusively take showers to get clean, you probably don’t think twice about the drain plug, and might not even own one. For a relaxing bath, however, the drain plug is even more important than candles and a rubber ducky. Read on for tips on how to install a universal drain plug if yours is missing or malfunctioning.

Even a tiny leak around the seal of a stopper can be annoying and wasteful. Perhaps the old plug has become lost or broken, or you’re tired of dealing with a standalone plug that gets in the way when you aren’t using it.

Can I Hook Up a Shower and Tub Drain To a Washing Machine Drain?. A variety of different pipes go through a home, ranging from the hot and cold water inserts to the drainpipes for the shower and bathtub, toilet, washer and dryer, sink and dishwasher. Tying a shower and tub drain to the same drain as the washing machine is feasible as long as you.

Pop-ups are simple mechanical devices that use a system of links and levers to move a drain stoppers up and down to seal a sink bowl or bathtub. How a Pop-Up Stopper Works Pop-ups are simple mechanical devices that use a system of links and levers to move a drain stoppers up and down to seal a sink bowl or bathtub. Bathroom sink pop-ups are raised and lowered with a lift knob or lever, usually located on or near the faucet body. This rod pushes the stopper up or lets it drop down into the drain body.

The lever operates a lift linkage that pulls on a spring. The spring pulls a rocker arm that raises and lowers the stopper see the illustration above. Pushing the knob and the lift rod down causes the pivot rod to push the stopper up. Pulling the knob causes the pivot rod to pull the stopper down. If you want to remove the assembly, you may be able to pull it right out.

Clearing a Clogged Bathtub Drain

Start out by removing the drain stop by simply unscrewing it. Then, take a tub drain remover, insert it into the drain, and twist it out counter-clockwise. You may need to insert a screwdriver for more leverage. Then, take a screw driver and remove the cover plate from the overflow drain. See the video for more detail. Then, you can lift out the tub by lifting the side opposite of the drain and then pulling the tub out at an angle.

May 06,  · Hey Folks, Got the old tub out, easy part. Hard part (for me) I have the drain exposed (see pics below) but can’t figure out how to assemble from the hole in the tub, to the drain itself in a secure, watertight, manner.

The drain basket which connects to the drain shoe, and the drain overflow which connects to the drain shoe pipe. When these two parts connect together, they flow into the drain waste pipe which connects to the sewer or septic drain pipe. Virtually anyone with do-it-yourself experience will be able to connect a tub drain, and only basic tools are needed for this endeavor.

The top of the “T” connector will have an expanded opening that the overflow pipe will slide into. Insert the drain shoe extension into the “T” connector but loosely tighten the slip nut. The degree “T” opening is where the shoe extension fits, and the lower non-expanded pipe fits into the drain pipe proper. Turn the drain shoe extension slip nut just enough to hold the pieces together but do not firmly tighten. If any of the pieces are too long for your application, cut them to size with a hacksaw.

BrightNest’s mission is to make homeowners happy.

Feb 18, – Remove the two screws from the trip lever faceplate to free the faceplate from the overflow tube. Gently pull the face plate away from the tub.

How to Install a New Bathtub; If you have any misgivings about doing it, hire a plumber who has the experience to install it and the license to hook up the fixtures. You may want to leave the drain linkage and pop-up assembly out of the tub until you set it in place.

By James Clark SAVE You can hook up a full-size washing machine to the faucet on most kitchen sinks using an adapter for the water intake and drain hoses. This can be a temporary solution if you are having plumbing work done in the laundry room, or have moved into a home without standard washer connections. The faucet adapter is available at hardware and plumbing supply stores.

Hooking up the washing machine to the sink takes less than five minutes. Hook up the waher adapter to your kitchen sink for a temporary laundry solution. Step 1 Position the washing machine so the back panel faces the kitchen sink. Step 2 Connect the cold-water supply hose on the back of the washing machine to the threaded inlet connection on the adapter and tighten with pliers. Step 3 Loosen the screw on the clamp over the drain hose on the adapter. Insert the end of the drain hose attached to the washing machine into the drain hose on the adapter and tighten the screw in the clamp.

Step 4 Remove the aerator on the end of the kitchen faucet. The aerator and screen unscrew from the tip of the faucet. Step 5 Connect the faucet adapter to the end of the faucet, turning the threaded coupler clockwise to tighten. Step 6 Adjust the water temperature to the desired level using the kitchen faucet knob or knobs. Step 7 Set the temperature selector knob on the washing machine to “Cold” regardless of whether you are washing in hot or cold water.

How to Install a New Bathtub

You might just want to banish all traces of the decorating schemes of the s, or need to add functionality or ease of cleaning. No matter the reason, bathtubs are added and replaced by homeowners on a regular basis. The most difficult part of installing the tub itself is hooking up the bathtub drain to the rough plumbing. If there is no access to the drain from behind or below, and your tub is sitting in its permanent spot, it is best to consult an expert to hook-up your drain.

Aug 22,  · Building the rack for the tub and installing the tubs, drain lines at the burnt house.

But will this bathing solution truly deliver all the safety, convenience, and comfort you desire? Common Misconceptions about Walk-in Bathtubs The following paragraphs highlight common misconceptions about walk-in bathtubs: To put this more bluntly — once you have stepped into the bathtub naked and pulled the door closed behind you, you could find yourself waiting up to 10 minutes or more for the water to rise slowly from your toes upwards.

Then at the tail end of the bath you can again be waiting as much as 10 minutes or more while sitting naked, cold and wet waiting for the tub to empty. The filling and the draining times for walk-in tubs vary based on the size of the tub, as well as on the plumbing in your home. And, if you are of an average or above average height, there is a good chance that only the lower half of your body will be fully submerged.

So if you are envisioning warm water soothing your aching back, neck and shoulders, you are likely to be left feeling sorely disappointed. A satisfactory bathing experience? If you are someone who relies on a walker for stability, then this is likely to be more stepping and maneuvering than you will feel safe and comfortable doing. A safety concern for the classic-style walk-in tubs with an inward-opening door is that if you do experience a medical emergency when you are inside the tub, it is not possible to open the door and get out without first letting all the water drain out — and notably these tubs can hold up to gallons of water!

My own patients were the first to report experiences to me about getting trapped inside of a walk-in tub. Additional reports are also evidenced in articles online, as well as in the readers comments attached below. The reasons have ranged from being unable to drain the water out of the tub to slipping off the seat and becoming awkwardly wedged behind the door, both of which make it impossible to open the inward-opening bathtub door.

The combination of the high tub walls and inward-opening door then makes it quite a feat for EMTs to get people out.

One more step

Using a Drain Claw 1 Remove the strainer. Hair and soap often accumulate underneath the strainer, which is located in or over the drain. Though many strainers can be removed manually, some have screws that will need to be removed, too. Remove the screws with the proper screwdriver. If you do not know which type of screwdriver to use, match the screwdriver to the screw head. Turn each screw surrounding the strainer until all are loose.

The most difficult part of installing the tub itself is hooking up the bathtub drain to the rough plumbing. If there is no access to the drain from behind or below, and your tub is sitting in its.

A blocked or clogged drain is a pain, but it doesn’t mean that you need to call a plumber. Most clogged drains can be easily cleared by using things that are around the house or just a few inexpensive tools. Drain Anatomy All drains have a similar construction. At the bottom of the drainpipe is a curved section of pipe called a trap; under the sink, this trap is shaped like an “U. Over time, however, the traps sometimes get blocked with things like cooking grease or food particles in kitchen drains or hair and soap scum in tubs and bathroom sinks.

Slow running drains are partially blocked, and drains that don’t drain at all are obviously totally blocked. Clearing Out a Blockage The first step in unblocking a bathtub drain is to look at it and see if you can spot what’s blocking it. In bathtubs, often a build up of hair and scuzzy soap scum will actually close up a drain. If you can see hair in the bottom of the drain, you can often just reach in and pull the clog out.

Since that’s not a lot of fun, you might want to try bending a wire coat hanger to hook onto the clog to pull it out. Alternatively, a pair of tweezers might work, or even a pair of needle nose pliers. Using a Plunger If you can’t see the clog to pull it out, your next step is to try plunging the drain. A plumber’s helper—plunger to some of us—didn’t get its name without good reason, and it is one of the first tools a pro would use to clear a blocked drain. Put enough water in the bathtub or sink to cover the bottom of the plunger, block the overflow outlet with a rag, put the plunger over the drain, and push down and up five or six times.

How to Unclog a Bathtub Drain Without Chemicals

Remove the two screws holding the trip lever plate to the tub wall. Put screws in safe place, so they don’t fall down the drain. Grasp the trip lever plate and carefully pull out the brass waste-and-overflow linkage. If the cylindrical brass plunger isn’t attached to the end of the linkage, use a flexible retriever to reach down into the overflow hole and grab the plunger. Once you’ve retrieved the plunger, hook it back onto the end of the linkage rod and pinch it closed with pliers.

Check to be sure the plunger can’t slip off.

The overflow tube the brass vertical pipe had come loose from the tub, so water would spill into the crawl space. This I could see when I first examined the house. But when I replaced the ancient tub faucet which had no shower with a proper tub-and-shower faucet, I noticed that the drain was loose where it attached to the tub.

But that wasn’t the worst of it The drain pipes had completely separated. The pipe on the right red arrow is a flexible plastic drain component, and it had completely detached itself from the tub drain. The tub had been draining into the crawl space for who knows how many years!

How To Install a Clawfoot Tub